GPS/GNSS Firewall & Antennas
GPS/GNSS Firewall and Antennas
Properly and securely connect your network with GPS/GNSS Antennas and enhance the security for those signals with BlueSky Firewall. Syncworks has product solutions to enable you to confidently grow, problem-solve and safeguard your network.
BlueSky GNSS Firewall 2200
The vulnerability of GNSS systems to various signal incidents is well documented. The rapid proliferation of GNSS systems has embedded these vulnerabilities into critical national infrastructure as well as corporate infrastructures that rely on GNSS-delivered position, navigation and timing (PNT) for daily operations. The widespread deployment of GNSS makes it impractical to replace all fielded GNSS systems in a timely or cost-effective manner.
BlueSky GNSS Firewall 2200
The vulnerability of GNSS systems to various signal incidents is well documented. The rapid proliferation of GNSS systems has embedded these vulnerabilities into critical national infrastructure as well as corporate infrastructures that rely on GNSS-delivered position, navigation and timing (PNT) for daily operations. The widespread deployment of GNSS makes it impractical to replace all fielded GNSS systems in a timely or cost-effective manner.
Global GNSS Timing Antennas GNSS1-TMG-40NCS
GNSS Systems Covered: GPS L1, GALILEO E1, GLONASS L1 & BEIDOU B1
PCTEL’s GNSS1-TMG-40N global GNSS timing reference antennas are specifically designed for long-lasting, trouble-free deployments in congested cell-site applications. The low noise, high gain amplifier is well suited to address attenuation issues associated with applications requiring longer cable runs.
The proprietary quadrifiliar helix design, coupled with multi-stage filtering provides superior out-of-band rejection and lower elevation pattern performance than traditional patch antennas. This multi-band antenna covers GPS L1, GALILEO E1, GLONASS L1 as well as BEIDOU B1 frequencies.
- Description: GNSS Antenna 40dB (GPS, GLONASS, GALILEO & BEIDOU, MARINE MNT)
- Syncworks Part # 30-20002-GNSS
- Manufacturer Part # GNSS1-TMG-40NCS
26 dB Antenna GNSS1-TMG-26NCS S30-20001-GNSS
PCTEL GNSS1-TMG-26N
26 dB Antenna
PCTEL GNSS1-TMG-26N global GNSS timing reference antennas are specifically designed for long-lasting, trouble-free deployments in congested cell-site applications. The low noise, high gain amplifier is well suited to address attenuation issues associated with applications requiring longer cable runs.
GPS Line Amplifier with L1 Bandpass Filter
Provides Gain to Overcome Cable Loss
The 58529A GPS Line Amplifier with L1 Bandpass Filter provides gain to overcome cable loss in installations where a GPS receiver and antenna must be separated by large distances.
With over 20 dB (typical) of gain, the 58529A increases the maximum cable length from 115 to 240 meters between the 58532A GPS Antenna and a timing receiver. Two amplifiers may be used in series to achieve distances up to 360 meters. An active device, the 58529A accepts power between +4.5 Vdc to +13 Vdc. The unit is designed to pass dc power up to the GPS antenna.
GPS Line Amplifier with L1 Bandpass Filter
Provides Gain to Overcome Cable Loss
The 58529A GPS Line Amplifier with L1 Bandpass Filter provides gain to overcome cable loss in installations where a GPS receiver and antenna must be separated by large distances.
With over 20 dB (typical) of gain, the 58529A increases the maximum cable length from 115 to 240 meters between the 58532A GPS Antenna and a timing receiver. Two amplifiers may be used in series to achieve distances up to 360 meters. An active device, the 58529A accepts power between +4.5 Vdc to +13 Vdc. The unit is designed to pass dc power up to the GPS antenna.
GPS Lightning Arrestor
Lightning arrestors will protect your systems from lightning damage. In-line lightning arrestors are mounted on a low impedence ground between the antenna and the point where the cable enters the building. This is a commonly used configuration since there is often a good ground nearby to connect to. The lightning arrestors require no additional power or wiring except the ground lead.
GPS Lightning Arrestor
Lightning arrestors will protect your systems from lightning damage. In-line lightning arrestors are mounted on a low impedence ground between the antenna and the point where the cable enters the building. This is a commonly used configuration since there is often a good ground nearby to connect to. The lightning arrestors require no additional power or wiring except the ground lead.
GPS Active Splitter
Provides Dependable Signals
4:1/2:1 Active Splitters allow multiple GPS receivers to share a single antenna. Designed for both manufacturing and position/timing redundancy applications, the 58536A GPS L1 Active Splitter provides dependable signals for up to four GPS receivers. For large manufacturing facilities, the Microsemi 4 port Active Splitter 58536A can provide as many GPS-L1 (1575.42 MHz) signals as your manufacturing floor requires. With built-in amplification to overcome splitter losses, the Active Splitter can be conveniently cascaded without adding separate amplifiers and bias-tees between splitters.
GPS Active Splitter
Provides Dependable Signals
4:1/2:1 Active Splitters allow multiple GPS receivers to share a single antenna. Designed for both manufacturing and position/timing redundancy applications, the 58536A GPS L1 Active Splitter provides dependable signals for up to four GPS receivers. For large manufacturing facilities, the Microsemi 4 port Active Splitter 58536A can provide as many GPS-L1 (1575.42 MHz) signals as your manufacturing floor requires. With built-in amplification to overcome splitter losses, the Active Splitter can be conveniently cascaded without adding separate amplifiers and bias-tees between splitters.